C Series Puller

• 4:1 design factor lifting, lowering and pulling. Meets ASME B30.21.
• Overload safety handle designed to noticeably bend.
• Lightweight aluminum frame.
• Alloy steel load hook with safety latches.
• One piece cast aluminum drum.
• Buttress tooth design improves load gear life.
• Solid steel drive and holding dog, not laminated plates.
• Galvanized aircraft quality wire rope.
• Ratchet and pawl system provides safe, "one notch at a time" lowering.
• Cable guide and shield protects wire rope and spools cable evenly on drum.
• Reversible handle changes position easily, so pull is always possible in the right direction against the load.
• Easy to repair, replacement parts available.
• Plated external parts for corrosion resistance.

• Three hooks allow 2 ton capacity; 6 foot pull with double line and 1 ton capacity with 12 foot pull using single line.
• Non-conductive, corrosion resistant, high strength synthetic strap will not kink or bind.
• Easy pay out of strap for fast set-up.

Overload safety handle is designed to bend when an overload is detected. Once the handle begins to bend, any additional force will result in additional bending limiting the hoist from lifting beyond it's capacity.